Resizing a Rhinestone File

The diameter of the circles that make up the design are set to cut a specific hole size to fit the rhinestone size listed on the listing image.  When you adjust the size of the design it will also change the size of those circles so you will have to use a larger or smaller stone size than what the design was created for.  You can only adjust the size of the design to the point where the circles will cut the correct size hole for a larger or smaller stone size.   Below is a list of stone sizes and what the dimensions of the circles need to be in order to cut the correct size hole in your template.

ss06 (2mm) - .098 inches or 2.5mm
ss10 (3mm) - .13 inches or 3.3mm
ss16 (4mm) - .173 inches or 4.4mm